Comments on: Bad Boy v2 – Step 1 – Tail Servos http://fangin.com/blog/2007/02/17/bad-boy-v2-step-1-tail-servos/?utm_source=rss&utm_medium=rss&utm_campaign=bad-boy-v2-step-1-tail-servos RC, photos & tech Fri, 13 Mar 2020 08:32:20 +0000 hourly 1 https://wordpress.org/?v=5.1.18 By: frans agusta http://fangin.com/blog/2007/02/17/bad-boy-v2-step-1-tail-servos/comment-page-1/#comment-4905 Tue, 09 Jul 2013 22:18:19 +0000 http://fangin.com/blog/?p=77#comment-4905 ok thank you very much I’ve just already ordered as yours

]]>
By: mattmc http://fangin.com/blog/2007/02/17/bad-boy-v2-step-1-tail-servos/comment-page-1/#comment-4904 Tue, 09 Jul 2013 00:05:22 +0000 http://fangin.com/blog/?p=77#comment-4904 Not sure what the minimum is but I can tell you I was using standard Hitec HS-311 Analogue servos.

http://www.servocity.com/html/hs-311_standard.html

 

]]>
By: frans agusta http://fangin.com/blog/2007/02/17/bad-boy-v2-step-1-tail-servos/comment-page-1/#comment-4903 Mon, 08 Jul 2013 10:40:53 +0000 http://fangin.com/blog/?p=77#comment-4903 mattmc, what is the minimum servo spec if using Hitec brand for aileron, rudder, elevator and throttle control this kit? thanks

]]>
By: mattmc http://fangin.com/blog/2007/02/17/bad-boy-v2-step-1-tail-servos/comment-page-1/#comment-3754 Thu, 20 Aug 2009 10:38:36 +0000 http://fangin.com/blog/?p=77#comment-3754 Gary,
My version of the manual states “The CG location is about 142mm measured from the leading edge of the wing root”.

]]>
By: gary http://fangin.com/blog/2007/02/17/bad-boy-v2-step-1-tail-servos/comment-page-1/#comment-3753 Wed, 19 Aug 2009 17:30:00 +0000 http://fangin.com/blog/?p=77#comment-3753 A friend gave me a “Bad Boy” plane w/o manual. I am looking for the CG location. I would greadly appreciate any help with this info. Thanks

]]>