fangin.com RC, photos & tech

18Nov/102

Tricopter build: Yaw mount

The method I'm going to try for the yaw mount is to drill as far into the main arm as my drill bit will go and insert a 5mm carbon rod. Then drill through the remaining block, about 1.5" long which will be able to pivot on the carbon rod. The fit on the rod is snug but not too tight. The hardest part was drilling a vertical hole in the centre of the 12mm x 12mm Tas Oak arm without going crooked and drilling out the side.

Comments (2) Trackbacks (0)
  1. Get out of the bloody shed and go for a walk!!!! …and don’t forget your parachute pants!

  2. its meant to be for xmas.. 🙂


No trackbacks yet.

%d bloggers like this: